Home - Knowledge - Details

Installation of aluminum tube fin evaporator for air cooled display cabinet

Installation procedure

 

1. Place the evaporator

Place the evaporator in the pre-planned installation position to ensure that it maintains a certain distance from the wall to avoid leakage and affect heat dissipation.
If the evaporator is large or heavy, more than one person may be required to assist or use lifting equipment.

2. Fixed evaporator

Use tools such as expansion screws or plugs to secure the evaporator in the installation position. Ensure that it is firmly fixed to avoid shaking or falling off during use.

3. Connecting pipes

Connect the evaporator to other parts of the refrigeration system, including condensate, pumping and freon pipes.
Tighten the pipe connector using tools such as a wrench to ensure no leakage.

4. Electrical connection

Insert the cable of the evaporator into the corresponding interface and secure the wire.
Ensure that the electrical connection is correct to avoid safety accidents such as short circuit or electric shock.

 

Debugging and inspection after installation

 

 

Test run:
After the installation of the evaporator, a trial run is carried out to check whether its working state is normal.
The working state of the evaporator can be judged by observing its working sound, temperature change and humidity change.
Check for leaks:
Use professional leak detection tools to check the refrigeration system to ensure that there is no leakage of freon or other refrigerants.
If a leak is found, it should be repaired and re-tested in time.
Adjust parameters:
According to the actual needs of the display cabinet, adjust the working parameters of the evaporator, such as temperature setting value, humidity setting value, etc.
Ensure that the evaporator can operate in the best condition to improve the cooling effect and energy efficiency of the display cabinet.

 

 

Send Inquiry

You Might Also Like