Bending process of finned condenser copper tube
Leave a message
Bending process
Preliminary preparation
Material selection and inspection:
Determine the material, specification and thickness of fins and copper tubes to ensure that they meet the design requirements.
Check whether the surface of the copper pipe is smooth, without cracks, rust and other defects.
Equipment preparation:
Prepare bending equipment, such as bending machines, molds, fixtures, etc., and ensure that they are in good working order.
Select the appropriate mold and fixture according to the specifications of the copper pipe.
Process step
Fixed copper pipe:
Place the copper pipe in the clamp of the bending machine to ensure that the copper pipe is stable and does not shake.
As required, the copper pipe is precisely positioned at the bending point using a fixture or positioning device.
Adjust bending parameters:
According to the material, specifications and bending Angle requirements of copper pipe, adjust the parameters of the bending machine, such as bending Angle, bending speed, bending strength, etc.
Perform bending operations:
Start the bending machine and make the mold bend the copper pipe according to the preset Angle and path.
During the bending process, pay attention to the deformation of the copper pipe to ensure that the bending Angle is accurate and the bending part is smooth and wrinkle-free.
Check and correct:
After the bending is completed, the bending part of the copper pipe is checked to confirm whether it meets the design requirements.
If the bending Angle deviation, folding and other problems are found, it is necessary to correct or re-bend in time.
Matters needing attention
Protect copper pipe surface:
During the bending process, measures should be taken to protect the surface of the copper pipe from scratches or crushing.
A lubricant can be applied to the surface of the copper tube or a soft material can be used to wrap the mold to reduce friction and damage.
Control bending force:
The bending strength should be moderate, too large may lead to fracture or serious deformation of copper pipe; Too small may not achieve the desired bending effect.
Maintain mold accuracy:
Check and maintain the bending die regularly to ensure that its accuracy and surface finish meet the requirements.
If the mold is found to be seriously worn or deformed, it needs to be replaced or repaired in time.
Follow safe operating procedures:
When bending, follow the safety regulations and precautions of the device.
Wear protective equipment such as gloves and goggles to prevent accidental injury.







