What should be done if there is leakage in evaporative condenser
Leave a message
Evaporative condenser in the use of many customers will often reflect the phenomenon of leakage. Many customers will choose to repair their own often appear uneven welding phenomenon, it is recommended that when repairing welding, should first clean the evaporator leakage around the hole, and then repair according to the following methods:
First, aluminum and tin are melted into two millimeters of aluminum tin electrode, and then 300 watts of electric iron is melted, while heating and friction are carried out around the leak hole. The second is to remove the waste circuit board copper layer, and then the remaining reoxy resin ground into powder, after screening and mixed with rosin to make flux. Place a small amount of flux around the leak. Then rub the iron and the electrode where there is a leak, so that the leak can be welded.
Then the self-coagulating powder and self-coagulating water in accordance with ten to six, and wait for a few minutes, a little of the mixture can be spread on the leak hole. Take 1% dilute phosphoric acid solution and clean up around the leak hole. For the evaporator copper tube evaporator, the leak usually appears in the welding place, after finding the leak hole, the leak should be repaired in time. For the evaporator that can be repaired without disassembling the evaporator of the display cabinet, the seal on the compressor of the evaporator of the display cabinet should be cut before the repair welding, and the evaporator of the display cabinet should be slightly heated, so that the steam generated by the refrigerant in the evaporator of the display cabinet can be discharged from the seal.
When repairing welding, it is necessary to use a silver gun welding, and usually use a small welding gun and welding nozzle, at the same time, the flame cannot be too strong, and shorten the welding time as much as possible, and the action is fast and accurate to repair the leak, to prevent the heating time is too long leading to a large area of deformation of the display cabinet evaporator.







