Finned evaporator cleaning work
Leave a message
Preparation: Before cleaning, make sure to turn off the air conditioning power supply and disconnect the power plug to prevent accidents during cleaning. At the same time, prepare the necessary tools and cleaning agents, such as spray bottles, clean rags, vacuum cleaners and gloves.
Air purging: The wing evaporator can use the air purging method, the use of sufficient gas volume, so that the flow speed of the purging gas is greater than the normal operating gas flow rate, generally the minimum is not less than 20 meters per second. This purges out residual attachments from pipes and equipment, ensuring thorough cleaning.
Clean the fins: If there is a lot of dust on the fins, you can first clean the dust and debris with a soft brush or a vacuum cleaner. Especially for the dust accumulation in the fin gap, a small vacuum cleaner can be used to remove it to avoid contamination to other parts during the cleaning process.
Spray cleaning agent: Use the nozzle cleaner to clean the evaporator fins, clean from the top down along the direction of the fins, and spray evenly on the fins from left to right. Ensure that the cleaning foam completely covers the surface of the evaporator to maximize the penetration effect of the cleaner.
Cleaning and wiping: Wait about 15 minutes for the cleaner to take full effect and disintegrate stubborn dirt on the fins. Then, the entire evaporator is cleaned with running water to rinse off the dirt and detergent. Finally, wipe the fins dry with a clean rag to ensure that the surface of the fins is dry.
Installation and inspection: Reinstall the cleaned evaporator into the air conditioner and cover the air conditioner housing. Make sure the case is securely mounted, and you can't get it in place until you hear a snap. After the installation is complete, start the air conditioner again and check whether the evaporator is working normally to ensure that the cleaning work has not affected the performance of the air conditioner.







