Home - Knowledge - Details

Aluminum tube fin evaporator inspection steps

1. Material inspection


Verify that the brands, specifications and models of aluminum tube and fin materials meet the design requirements.
Check the material for obvious defects, such as cracks, scratches, oxidation, etc.

2. Size check


Use calipers, vernier calipers and other accurate measuring tools to check the length, width, thickness and other dimensions of aluminum tubes and fins to ensure that they meet the design requirements.
Check whether the gap between the fin and the aluminum tube is uniform and ensure that the fin is firmly installed.

3. Appearance inspection


Observe whether the surface of the aluminum tube and fin is smooth and smooth, without obvious bumps, scratches and stains.
Check the fins for distortion, distortion, or breakage.

4. Welding quality check


For the welding parts, check whether the weld is smooth, smooth, no welding bumps, edges, pores and other defects.
Use the corresponding inspection tools or methods to check the internal quality of the weld to ensure that the welding quality meets the requirements.

5. Air tightness check


Perform an air tightness test on the evaporator to ensure that there is no leakage inside the evaporator.
Commonly used air tightness test methods include pressure leak detection method, vacuum leak detection method and so on.

 

6. Performance test


Under the appropriate temperature and humidity conditions, the evaporator performance test is carried out to check whether its evaporation effect, heat dissipation performance and energy efficiency ratio meet the design requirements.
Record the data during the test, such as refrigerant flow, pressure, temperature, etc., for subsequent analysis and improvement.

 

 

Send Inquiry

You Might Also Like